Step 03 / your botContinue in Telegram
1. Token and your ID
Open @BotFather → /newbot → display name → a free username ending in bot. Save the token in your password manager. Ask @userinfobot for your numeric ID, not your @username.
2. Return to the Hermes wizard
On the Telegram screen, enter the token and only your ID in the allowed users list. Leave Allow all off. Do not add groups or approve someone else’s pairing code.
3. Check and start the gateway
After saving settings, open the shell in the same container. Run hermes gateway status. If it shows Manager: s6 and the gateway is stopped, run hermes gateway start, then hermes gateway status again. Do not start an already running gateway; to reload changed settings, use hermes gateway restart through that same s6 manager.
If s6 is not shown or the command is unsupported, do not install a host service or start a second copy. Ask Hostinger how your installed image runs the gateway in the background. A reply in the terminal chat alone is not sufficient.
4. Message your bot
Open it in Telegram → Start → write: “Reply with one word: ready.” Wait for the answer, close the terminal tab and send a second question from your phone.
The bot should reply with the tab closed. If it only responds while the terminal is open, background operation is not ready. Check the project in Docker Manager and ask support with an error description, without the token.
This Hermes runs in Docker. Do not install a second systemd service for it on the VPS. Never use the same token in two running gateways.
Save a backup before changing configuration. After a change, ask a new question in Telegram. Do not create a duplicate project or delete the working container just to repeat setup.
The token controls your bot. If exposed in a message or screenshot, revoke it through BotFather and enter the replacement in Hermes settings.